+86-15963404599          info@esenwood.com
How to Repair a Shipping Container Door Seal or Gasket
Home » News » How to Repair a Shipping Container Door Seal or Gasket

How to Repair a Shipping Container Door Seal or Gasket

Publish Time: 2023-05-16     Origin: Site

The door seal, or gasket, of a shipping container is a crucial component regardless of what the container is being used for. The gasket seals the door completely to keep the container contents from leaking and prevent water and vermin from getting inside.


From time to time, you may need to repair or replace your door gaskets or seals. In this guide, we will focus on what you need to do to repair your gaskets. Replacing them entirely is a different procedure, where you will need to take out and install a whole new set of material, but the repair process is a little more straightforward and cost-effective.


Wear and tear will generally cause seals to break down over time. However, if your seals are tearing away, it is time to take immediate action. Here’s how to repair a shipping container door seal.

You’re going to need a sharp knife, a drill and bits, a chisel, a joint sealer and a hammer. Furthermore, this procedure will require a new gasket to make the repair.



Step 1: Removing Your Old Gasket Piece

The first step you should take is to closely look at your damaged seal or gasket. Mark clearly, on the seal itself, where you need to make repairs.

Once you are clear which areas of the gasket need repair, use a sharp blade to cut into your marks. You may need to use a small saw, in the meantime, to remove any remaining pieces from your marked zone. You will also need the tool to cut and remove any band strips in place. However, be sure to retain any that you remove.

You are then going to use a chisel. You’ll use it to tap off any fasteners left in place, which are used to hold in the gasket.

Step 2: Inserting Your New Gasket Piece

Now, you are going to need to repair your gasket system by inserting a new piece of seal into the door. Simply measure and cut a new piece of gasket material as per the section you removed earlier. Once you’re happy with what you have cut, you will need to position it back in the door with the band strip you retained.

At this point, you will need to prepare your drill. Space two small holes around six inches apart on the strip and the gasket you wish to install. Drill through both pieces into the door frame. Once you have made the holes, you will need to knock the fasteners back in place with a hammer.

The final step, of course, is the sealing. Use an adhesive or sealant gun, as prepared, to seal in the gasket’s available joints.


Have you got a question or do you need more information? Browse through our resources page or feel free to contact us to learn more about shipping container cost and repair.


Contact Us

SHOUGUANG ESEN WOOD & ACCESSORIES CO.,LTD

CONTACT US

Address:BEILUO INDUSTRY ECONOMIC ZONE, SHOUGUANG,SHANDONG PROVINCE, CHINA
Contact Person:Ginna Fan
Mobile Phone: +86-15963404599
Fax: +86-536-5655432
Tel: +86-536-5655432
Copyright © 2023 SHOUGUANG ESEN WOOD & ACCESSORIES CO.,LTD. All Rights Reserved. Sitemap | Support By Leadong  | Privacy Policy